White Aluminum Fence – This is a really easy and relatively fun do-it-yourself project. Since aluminum fencing in prefabricated panels, you only need to worry about a limited scope of work and very few tools.
Place the fence line with a measuring tape and wooden poles. Run a string line between the stakes to mark the White Aluminum Fence. When the string line is complete, make sure it is square. Now mark your on-center seats for corner and end posts, then select your intermediate posts seats. Dig holes 24 inches deep and 18 inches around. Gate posts must be set with a greater foothold because they get ripped on continuously during their lifetime.
Set your posts in holes one at a time. Place a fence panel on the ground nearby, so you can use it to your posts asking the right width apart. Each time you set a record, use fast-curing concrete to fill the hole. Fill the hole with concrete until it is 4 inches below ground level. This allows you to pile dirt over concrete foundations and hide it later. Use a magnetic level to help you in the plumbing and leveling all posts.
Return to posts you have previously installed when you go to check their plumb and level. Straighten them as needed. You have to stay on it as the concrete is not set up for you with a post of solder and out of level. Place White Aluminum Fence, one section at a time, when the concrete has dried. This is usually as an erector set process and requires the nuts, bolts and screws fence provides. When the main fence runs are in, install gates.white aluminum fence